B&B Electronics Parallel Printer Card PIOC Instrukcja Użytkownika Pobierz pdf (Strona 45)

Naming/Renaming Setups

Figure 22. Renaming a setup.

A saved setup can be renamed in two steps.

First, navigate to the Rename line on page 1 of 1 of the set mode screen.

When the cursor is positioned on the Rename line, the first character position of the name

will begin to flash. In this line, the START button functions differently. It advances the

character position to the next character. To change the current character, rotate the rotary

dial. Proceed character by character until the full name appears in the display line.

The second step is this: advance to the “Save Rename To” line. Rotate the rotary dial to

select the setup to rename; then press START to rename the setup.

Editing Setups

To edit a setup,

• load the setup into T35-GFX active memory

• make changes to the desired settings in the active memory

• save the setup.

That’s all there is to it.

Beeper

The T35-GFX contains an internal beeper that signals the end of cycle, as well as a

button press. The beeper action at the end of the cycle can be set to the OFF,

MOMENTARY, or CONTINUOUS modes.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 61 62

Brak uwag

B&B Electronics Parallel Printer Card PIOC Instrukcja Użytkownika Strona 45